Description

Included in the Package

Cleaning Mechanical Section

• Clean refrigerant lines
• Clean air filters
• Clean fan motors and blades
• Tighten screws, bolts, clamps, and secure loose wiring
• Inspect for signs of low refrigerant

Cleaning, Sanitizing & Flushing Internal Parts

• Disassemble interior components per manufacturer instructions
• Deep clean all parts using approved cleaning solutions
• Descale evaporator plates with nickel-safe chemical solution
• Apply decalcification solution to interior parts
• Complete sanitization of all internal components
• Perform two full flushes of the operating system
• Clean and sanitize inside of ice bin
• Inspect and clear ice bin drain; ensure code-compliant sanitary separation

Take and Record Baseline Measurements

We document performance metrics to verify that the machine operates within manufacturer specifications and identify potential issues.

We check:

• Inlet water flow rate (GPM)
• Inlet water temperature
• Water temperature during chilling cycle
• Incoming voltage
• Electrical systems (motors, relays, switches, capacitors, circuit boards)
• Amp draw on fans and compressor
• Electrical disconnect and whip condition
• Ice thickness gauge accuracy
• Weight of each ice batch versus expected standards

By comparing these readings to the manufacturer’s service manual, we can predict potential failures (like capacitor or compressor damage) and address them before they occur.